[rescue] Re: my latest haul (and QBus questions)

[Lord Isildur]

the CMD might be configured as a TMSCP device, and thus setaling the CSR 
for the first TMSCP device. i posted jumper settings for that card (a cqd423)
a while back, so check the jumpers/dip switches and see if its hogging the
CSR. if its set up for TMSCP, thats a waste, i'd use it for disk. tapes
are easily enough accessed over the network.. :)
(and a real TK50 is fine for just tape booting) 

otherwise, all normal Qbus rules apply. 

really nice machine though! congrats!!! 

happy hacking
isildur

On Sat, 21 Jul 2001, Brian Hechinger wrote:

> evening all,
> 
> drove an insane number of miles today, to pick up my new toy.
> 
> VAX 4000/500 with 64MB RAM
> LPV11-SA parallel card
> KZQSA SCSI card (no MSCP, but supported by OpenVMS, sooooooo)
> CMD SCSI card (MSCP BABY!)
> 
> ok, /500 will be a NetBSD box with that CMD card in it hands down, but i've got
> some QBus related questions as pertaining to it.  it's a half width card in a
> SBox thingie.  the other half of the "card" is black plastic.  are there any
> limitations for the QBus in the BA440 that would cause me grief with this thing
> as pertaining to bus grant cont.?
> 
> also, when i plug this thing in and do a SHOW DEV at the >>> i lose my TK50.
> 
> before:
> 
> DSSI Bus 0 Node 0 (R2CLJC)
> -DIA0 (RF72)
> 
> DSSI Bus 0 Node 1 (R2QSNC)
> -DIA1 (RF72)
> 
> DSSI Bus 0 Node 2 (R2ZDKA)
> -DIA2 (RF72)
> 
> DSSI Bus 0 Node 6 (*)
> 
> DSSI Bus 1 Node 7 (*)
> 
> UQSSP Tape Controller 0 (774500)
> -MUA0 (TK50)
> 
> after:
> 
> DSSI Bus 0 Node 0 (R2CLJC)
> -DIA0 (RF72)
> 
> DSSI Bus 0 Node 1 (R2QSNC)
> -DIA1 (RF72)
> 
> DSSI Bus 0 Node 2 (R2ZDKA)
> -DIA2 (RF72)
> 
> DSSI Bus 0 Node 6 (*)
> 
> DSSI Bus 1 Node 7 (*)
> 
> UQSSP Disk Controller 0 (772150)
> 
> UQSSP Tape Controller 0 (774500)
> -?
> 
> other than that, the CMS card also has an MMJ connector on it, what the heck
> is that for?
> 
> well, off to try and boot a VMS cd on this thing and get 7.2 on my cluster.
> 
> -brian
>