[rescue] If Larry Snyder is still following. . . .

[Kevin Loch]

Well, it's always good to have a set of torx bits lying around
but you are describing something different than what I was thinking
of.  I was looking at the hot swap "sliders" that the A1000, E450 etc
use.  Incidentally, the A1000 drives also have an aluminum vented plate
attached to the bottom.  Everything is attached with torx screws.

KL

"Forrest J. Cicogni" wrote:
> 
> Oh, goody, somebody got back to me!
> 
> The drives are encased in gray plastic with diagonal vents on the front, a
> two-inch purple lever, and no "visible" screws. They bear a SUN PART #:
> 5402784-03. I'm guessing the two torx heads visible through each of the side
> slots are what you are referring to, so I am going to run to the hardware
> store to find myself that tool. Please, if I am making a fatal mistake, let
> me know.
> 
> Thanks!
> 
> -Forrest
> 
> _______________________________________________
> rescue maillist  -  rescue at sunhelp.org
> http://www.sunhelp.org/mailman/listinfo/rescue