[rescue] How the fsck do I install gzip from a "depot" file on an HP-UX 10.20 box?

[Ken Hansen]

Thanks for the great link, it was helpful.

But I still can't get the software installed, I suspect the OS install is a
bit off - in the log file (swagent.log IIRC) it talks about unable to
connect/losing RPC link to my hpbox).

I am going to await OS media (already en route), and start from zero with a
fresh disk and build the machine up... Should be fun, I've never done this
before on an HP box.

My goal will be to set this unit up as an X terminal on my PS/2 KVM in my
den...

Thanks everyone for the assistance...

Ken

----- Original Message -----
From: "Loomis, Rip" <GILBERT.R.LOOMIS at saic.com>
To: <rescue at sunhelp.org>
Sent: Sunday, September 23, 2001 11:01 PM
Subject: RE: [rescue] How the fsck do I install gzip from a "depot" file on
an HP-UX 10.20 box?


> For the categorical answer, see the HP-UX
> porting center at
>   http://hpux.cs.utah.edu/
> or the "centre" at
>   http://hpux.connect.org.uk/



_________________________________________________________
Do You Yahoo!?
Get your free @yahoo.com address at http://mail.yahoo.com