[rescue] Vaxen?

[Dave McGuire]

On April 29, Brian Hechinger wrote:
> > If anyone is _serious_ about this, I do know of an extremely talented
> > designer that could probably whip this out in his sleep.  Cost for board
> > would probably be in the neighborhood of $50/ea for parts/pcb, and 1-2
> > hours of assembly time for someone used to soldering surface mount parts
> > with 0.5mm pin spacing.  Sometimes mild nearsightedness isn't so bad.  :)
> 
> ok, i doubt i have the skill to solder something like that.  i do NOT have
> fine motor control.  so what do you estimate the cost of assembly would be?
> so far $50 sounds like a good deal.  i'd be willing to pay that.

  I can solder them.

      -Dave

-- 
Dave McGuire                                 "Mmmm.  Big."
St. Petersburg, FL                                -Den