[rescue] Service mode access on SPARC Enterprise M3000

[Larkin Nickle]

login: default
Change the panel mode switch to Locked and press return...
Leave it in that position for at least 5 seconds.  Change the panel mode 
switch to Service, and press return...
XSCF> showstatus
No failures found in System Initialization.
XSCF> poweron -y -a
DomainIDs to power on:00
Continue? [y|n] :y
00 :Powering on

*Note*
  This command only issues the instruction to power-on.
  The result of the instruction can be checked by the "showlogs power".
XSCF> console
Invalid parameter.
usage : console -d domain_id [[-q]{-y|-n}] [-f|-r] [-s escapeChar]
         console -h
XSCF> console -d 00

Console contents may be logged.
Connect to DomainID 0?[y|n] :y
POST Sequence 08 Memory
POST Sequence 09 Raw UE In Cache
POST Sequence 0A Floating Point Unit
POST Sequence 0B SC
POST Sequence 0C Cacheable Instruction
POST Sequence 0D Softint
POST Sequence 0E CPU Cross Call
POST Sequence 0F CMU-CH
POST Sequence 10 PCI-CH
POST Sequence 11 Master Device
POST Sequence 12 DSCP
POST Sequence 13 SC Check Before STICK Diag
POST Sequence 14 STICK Stop
POST Sequence 15 STICK Start
POST Sequence 16 Error CPU Check
POST Sequence 17 System Configuration
POST Sequence 18 System Status Check
POST Sequence 19 System Status Check After Sync
POST Sequence 1A OpenBoot Start...
POST Sequence Complete.
ChassisSerialNumber [redacted]

SPARC Enterprise M3000 Server, using Domain console
Copyright (c) 1998, 2012, Oracle and/or its affiliates. All rights reserved.
Copyright (c) 2012, Oracle and/or its affiliates and Fujitsu Limited. 
All rights reserved.
OpenBoot 4.33.5.d, 16384 MB memory installed, Serial #10036154.
Ethernet address 0:b:5d:e2:23:ba, Host ID: 809923ba.



{0} ok

YAY! My system appears to be turning on now after rearranging the memory. :)