[rescue] New to me PDP-11/23+

[Joshua D. Boyd]

On October 11, 2022 2:46:10 PM EDT, Steve Hatle <steve.hatle at gmail.com> wrote:
>Thanks everyone - all good info!
>
>Unless I'm missing something, my board only has one SLU - J1. J2 is a 20 pin connector and would be used to bring out the DIP switch settings, etc. If there's another 10-pin hiding on there, I missed it, and the board is not handy to double-check. Also, see the pic here: https://gunkies.org/wiki/KDJ11-B_CPU
>
>I was hoping the answer to boot media would be as "simple" as making a bootable image and dd'ing to a Zip disk. I should be able to manage this along with building a console cable.
>
>I'm sure you'll hear more as I move forward!


So is there any chance you're going to be hooking that PDP 11/23 up to a newer laser cutter?