[rescue] Sun Blade 1000

Dan Moisa dmoisa at gmail.com
Mon Jun 14 16:37:49 CDT 2021


I also had problems with an Ultra10 not starting because the UPA card was
not fully inserted (behaved like dead power supply), so if it was recently
shipped I'd just take everything out and re-seat it, just to be sure.

Dan.

On Mon, Jun 14, 2021 at 2:34 PM Peter Stokes <peter at ashlyn.co.uk> wrote:

> Hi
>
> As mentioned there is a micro switch which is activated by the side panel.
> You
> can use a screwdriver to activate it with the side off to test it as
> sometimes
> the switch comes loose or the prong on the panel gets bent or broken.
>
> As to memory, I seem to remember there were third party 2Gb sticks which
> would
> give you up to 16Gb, or 12Gn if you used a mixture of Sun 1Gb and third
> party
> 2Gb.
>
> Peter
>
> Sent from my iPad
>
> > On 14 Jun 2021, at 20:33, Michael Thompson <
> michael.99.thompson at gmail.com>
> wrote:
> >
> > o;?I just got a Sun Blade 1000 with a single 750 Mhz CPU, 4GB RAM, no
> disk,
> > and Elite3D-m6 Series 2 graphics for free.
> >
> > I connected a known good and powered cord to the power supply and pressed
> > the power button on the front. Nothing happens.
> >
> > Is the power supply bad, or is there some other magic to getting it to
> > power up?
> >
> > --
> > Michael Thompson
> > _______________________________________________
> > rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue


More information about the rescue mailing list