[rescue] torque of CPU to CPU/RAM board of E4500

[Robert Toegel]

Well, my Ultra 80s have them on the chassis but you could miss them if you
don't know where to look.  Of course at my age, I could miss anything.

Nob

On Sun, May 2, 2021, 20:56 Thomas Pelki <thomas.pelki.1969 at gmail.com> wrote:

> Not sure where they are hidden *IF* they were on the E4000/E4500..
>
> -Thomas
>
>
> On Wed, Apr 28, 2021 at 9:50 AM Robert Toegel <rjtoegel at gmail.com> wrote:
>
> > You don't have the factory tool "hidden" on the chassis somewhere?
> >
> >
> > On Tue, Apr 27, 2021, 18:59 Thomas Pelki <thomas.pelki.1969 at gmail.com>
> > wrote:
> >
> > > does anyone know what the torque should be? I'm gonna be receiving new
> > CPUs
> > > and want to make sure I don't overtighten or under-tighten the CPU to
> the
> > > CPU/Ram board of my E4500.
> > >
> > > -Thomas
> > > _______________________________________________
> > > rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> > _______________________________________________
> > rescue list - http://www.sunhelp.org/mailman/listinfo/rescue
> _______________________________________________
> rescue list - http://www.sunhelp.org/mailman/listinfo/rescue